9
PRECAUTIONS
1.
A water-tight test without the camera inside the housing is highly
recommended when using the system for the first time and after the
changing of port and O-ring(s).
2.
O-rings should be kept clean and lubricated at all times. Discontinue
use immediately should you notice any leakage. Do not use lubricants
from other brands with the silicone rubber O-rings on this housing,
only use the lubricant provided by
ISOTTA
.
After checking the O-rings to make sure that there are no scratches,
dust, or debris, apply a light coating of silicone grease to the entire
O-rings with your finger.
Applying too much grease will make it easier for dust and debris to
adhere to the O-rings, and could cause flooding.
3.
When fitting the O-rings into the O-rings groove, insert it straight into
the groove; do not bend or twist it.
4.
Store the housing in a robust, shock-proof container during
transportation; avoid transporting with any equipment, such as a
camera, inside the housing, to avoid breakages.
5.
Do not open the housing in a sandy environment.
Protect the interior from moisture and debris in order to prevent
malfunction or leakage.
6.
Do not store the housing in an environment of high humidity.
7.
Do not leave the housing and the camera in direct sunlight for prolonged
periods.
8.
Do not store the housing in high temperature environment as in the car
cockpit under the sun.
9.
Keep out of reach of children.
10.
Always dry the front port, the lens, the flash window or the finder
using a soft cloth to prevent stain or salt residue from marring
the glass surface. Do not use solvent or alcohol to clean the port,
viewfinder or LCD window.
