13
NOTEWORTHY
OPENING AND LOCKING THE HOUSING
1.
The housing can be opened and closed by operating with only one
hand. When opening, pull the opening knob, then turn the knob
counter-clockwise until the outside housing opens.
2.
Remove the back of the housing by pulling it oblique slightly to
release the two pins. In this way, it will be possible to separate
completely the back housing from the front housing.
3.
To close, insert the two pins in their slots, insert the pins in the
space on the opening knob. While applying a gentle pressure on
the back of the housing screw the knob until the end, and push
it downwards to secure it safely. If you have not closed the back
properly you may feel resistance when turning the knob.
Open it again and check that camera is properly inserted, pins are in
their slots, verify the shoulder strap clips have been removed and try again.
4.
When closing, make sure there is nothing caught between the
closing surfaces of the two halves of the housing and check that
O-rings are clean.
N.B.
If you do not close the back housing correctly or there is
something preventing the correct closure of the housing, the camera
controls cannot work properly.
•
As for the push buttons and her functions please refer to the in-
struction manual of the camera in use.
•
To use the built-in strobe, mount the supplied diffuser, fitting it
into the groove of the port by placing the largest part in correspon-
dence with the built-in strobe.
•
To use an external strobe that works in synchrony with the integra-
ted one in the camera is necessary to bring the fiber optic contact in
front of the built-in strobe using the appropriate optional accessory.
>
>
>
