23
252_EN_IS_1_3_00.doc
MENU 11.INTERNAL DATA
(POS. 11.1) Level 2 access code set
[L2 KEYCODE=XXXXX]
Level 2 access code enter. This code is programmable by the user within the range 00001 -
65535. Setting such a value at 22222 the access code for levels lower than level 3 is disabled.
(see pag. 18)
(POS. 11.2) Block level
[BLOCK LEVEL =X]
Block level function can be set from 0 to 3. Every level enables and disables specific functions
(see pag. 23).
N.B.: the block levels are enabled only if the dip-switches on the back of converter are on
(POS. 11.3) Factory pre-set data loading
[LOAD FACT PRES.]
Re-set the default factory data. Any previous programming is cancelled getting back to the
manufacturer’s standard values
(POS. 11.4) User pre-settings loading
[LOAD USER PRES.]
This function recalls the values saved from the user.
(POS. 11.5) User pre-settings saving [LOAD USER PRES.]
This function saves the current programming as user pre-settings.
(POS. 11.6) Operation time
[HOURS=XXXXXX]
This function allows the visualisation of the total operation hours of the converter
(POS. 11.7) Set KS
[KS=±X.XXXX]
Set KS. These parameters give the possibility to change the calibration of the instrument without
change the values of plate (KA)
(POS. 11.8) Ignore calibration error
[Ign.cal.err= ON/OFF.]
This function if ON , ignore the calibration error during the switch on test. Default setting OFF,
the converter give alarm if present during the initial test.
