2-
1. Safety Instruction
WARNING
y
Please keep this User Guide for future consultation. If you sell the unit to another user, be
sure that they also receive this instruction booklet.
y
Unpack and check carefully there is no transportation damage before using the unit.
y
Before operating, ensure that the voltage and frequency of power supply match the power
requirements of the unit.
y
The unit is designed for use with the HID 150W or ELC 250W (two version). Do not use
any other type of lamp.
y
It’s important to ground the yellow/green conductor to earth in order to avoid electric
shock.
y
The unit is for indoor use only. Use only in a dry location.
y
The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces. Be sure that no ventilation slots are blocked.
y
Disconnect main power before fuse/lamp replacement or servicing.
y
Replace fuse/lamp only with the same type.
y
Make sure there is no flammable materials close to the unit while operating as it is fire
hazard.
y
Use safety cable when fixes this unit. Don’t handle the unit by taking its head only, but
always by taking its base.
y
Maximum ambient temperature is TA: 40
℃
. Don’t operate it where the temperature is
higher than this.
y
Unit surface temperature may reach up to 85
℃
. Don’t touch the housing bare-hand during
its operation. Turn off the power and allow about 15 minutes for the unit to cool down
before replacing bulb or serving.
y
In the event of serious operating problem, stop using the unit immediately. Never try to
repair the unit by yourself. Repairs carried out by unskilled people can lead to damage or
malfunction. Please contact the nearest authorized technical assistance center. Always
use the same type spare parts.
y
Don’t connect the device to any dimmer pack or power pack.
y
Do not touch any wire during operation as high voltage might be causing electric shock.
Please read carefully the instruction, which includes important information
about the installation, usage and maintenance.
3-
Warning
y
To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or
moisture.
y
Never touch bulb with bare fingers as it is very hot after using.
y
Hot lamp explosion hazard. Do not open the unit within five minutes after switching off.
y
Do not start on the unit without bulb enclosure or housing are damaged.
y
The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly
damaged.
y
Do not look directly at the light while the bulb is on.
Caution
There are no user serviceable parts inside the unit. Do not open the housing or attempt
any repairs yourself. In the unlikely event your unit may require service, please contact
your nearest dealer.
Installation
The unit should be mounted via its screw holes on the bracket. Always ensure that the
unit is firmly fixed to avoid vibration and slipping while operating. Always ensure that the
structure to which you are attaching the unit is secure and is able to support a weight of 20
kg for each unit.
2. Technical Specification
•
Voltage
：
AC 100V//120V/230V/240V/250V 50/60Hz
•
Bulb
：
HID 150W
ELC 250W
•
The unit is DMX 512 fixture. It features full DMX 512 control. It can be
also
linked together
in master/slave connection, as many as required and run by built-in program chase
sequences automatically or by sound activation through an internal microphone to create
an intelligent effect.
•
It can be operated by DMX 512 control or can be used as an individual unit without a
controller.
•
Features different preprogrammed chase patterns.
•
Please use a 3 pin XLR cable/plug when connecting
units
together.
•
Accurate focusable optics system and ultra smooth stepping motors, Fan cooled.
•
Pan: 540 deg. Tilt: 270 deg.
•
Dimension: 266 x 276 x 370mm
•
Weight: 10 kg
