iSMA-B-FCU /FCU Hardware
Version 1.1
www.gc5.pl
Page
14
/
37
Off
Add 0 to MAC Address
8
On
Add 128 to MAC Address
Off
Add 0 to MAC Address
Table 1 Setting MAC address with a Dip Switch
Example: Configuration setting of the ISMA-B-FCU device address 83.
Address 83 contains following multiplicity of number 2: 83 = 1 + 2 + 16 + 64. Address DIP switch
settings are presented in the table below. All addresses of DIP switch configuration are presented
in the table at the end of this document.
Address
S1
S2
S3
S4
S5
S6
S7
S8
83
On
On
On
On
Table 2 Address 83 DIP switch configuration
Figure 10 MAC DIP switch address 83 settings
WARNING! In BACnet network setting, the address above 128 automatically switches BACnet to
Slave mode. In this mode, the device cannot be discovered in device searching process.
WARNING! Do not set address 255 (all switches in ON position). This address setting is reserved
for system operation.
2.8 Baud rate selection
Transmission baud rate is determined by S3 switch (sections 1, 2, and 3) in accordance with the
following table:
1
2
3
Baud rate
OFF (0)
OFF (0)
OFF (0)
Defined by the user
OFF (0)
OFF (0)
ON (1)
76800
OFF (0)
ON (1)
OFF (0)
4800
OFF (0)
ON (1)
ON (1)
9600
ON (1)
OFF (0)
OFF (0)
19200
ON (1)
OFF (0)
ON (1)
38400
ON (1)
ON (1)
OFF (0)
57600
ON (1)
ON (1)
ON (1)
115200
Table 2 Baud rate selection
