18 - 27
2-4.1 Positioning and mounting
Installation holes for the attachment of the compact unit to the wall must be made in
accordance with the stipulations of the section mounting dimensions. (Fig.2)
The lubrication unit is attached to the intended mounting location using appropriate
fastening materials.(Fig.3)
The installation location should be spaced between 0.6m to 1.7m above the ground.
2-4.2 Filling
2-4.3 Lubrication line connection
Fig.4
4
Fig.5
Recommend filling by grease gun through grease
nozzle(Fig. 3) until the follower plate move to the MAX
mark. Use only new oil with a permitted range of grease
grade No.00/000.(Model with spring-loaded follower
plate can use No.0,1 grease)
Warning! Prohibit filling from the top of grease
reservoir.
Remove the plug from the lubrication unit first. Use
thread seal tape attached on the adapter(1). (Fig. 5)
Solderless tube connection (double tapered sleeves) can
be used. The tube must go through compressed bushing
and double tapered sleeve. To avoid any leaking during
running service time, it should be observed up to 1mm
distance between the tube(4) end to the double sleeve(2).
Insert tube end into counterbored port (1) up to the
stop. First tighten compressed bushing(3) finger-tight by
hand. Then turn another 11/2 turns.
3
2
1
Summary of Contents for YGL-G
Page 16: ...16 27 Fig 1 ...