ICP 3020 / ICP 4030 iMC-P Operating instruction
page 8
3 Safety instructions
Do not operate the machine in a potentially explosive atmosphere
The machine is fully enclosed.
The transparent panes (material: polycarbonate) mounted in the machine
frame resp. in the door ensure during operation of the machine (setup or
working process) protection against moving machine parts as well as
eventually thrown work piece fragments from the work area.
The housing protects you from moving tools, reduces the noise level and
holds back chips.
The door is
locked
during operation
and cannot be opened (safety
solenoid interlock). Please do not change or remove this mechanism.
You are not allowed to put a CE marked CNC machine into operation if
the enclosure is not complete, intact or the polycarbonate panes are
damaged.
The delivered CNC base machinery
without
safety door / hood are partly
completed machinery for the purpose of the directive 2006/42/EC. They are
delivered without a CE marking. It applies the declaration of incorporation
and the assembly instruction.
As the operator of the CNC base machine, you are responsible for
taking appropriate protective measures based on your risk
assessment to comply the requirements for the machine according to
Machinery Directive 2006/42/EC.
During operation of the CNC machine, we recommend the wearing of
appropriate hearing protection and appropriate protective equipment (e.g.
protective glasses)
Be careful that work pieces are tightly clamped. The use of save and
suitable parts / devices for work piece clamping is one of the tasks of the
operator of the CNC machine. Unsuitable not safe devices for work piece
clamping can cause unfasten of work piece from device during operation.
This can result in heavy damage and accidents with fatality or personal
damages. In this case can also damages of tool, work piece, clamping
device or other parts of the machine occur.
In case of emergency, you will find an emergency HALT switch on your
hand control unit / CNC control panel. It will interrupt power supply for the
power electronics (motor power amplifiers) and frequency inverter for main
spindle drive (STOP category 0
– interrupt of drives power supply)
The key switch on the hand control unit may be used only by
knowledgeable and instructed persons, because in TEST mode there is an
increased risk of damage.
