S p e z i a l e l e k t r o n i k G m b H
iseg Spezialelektronik GmbH
Email: [email protected]
Tel ++ 49 (0) 351 / 26 996 - 0
Bautzner Landstr. 23
http://www.iseg-hv.de
Fax ++ 49 (0) 351 / 26 996 - 21
D - 01454 Radeberg/ Rossendorf
5
The Standard units of the HPx
)1
- 300 W and 800 W series are with CAN- and RS232-Interface.
Available as options are:
- additionally IEEE-Interface and
- indirect coupled analogue I/O with V
SET/MON
= 0 up to 5 V instead of RS232-Interface.
In menu “SET“ under function 09 the interface of your choice has to be selected.
If an existing interface has been selected by menu „SET“ the control of the device will be activated
automatically due to receipt of the according commands coming in ( e.g. from a PC ) and the yellow
LED is flashing.
By pushing the push button „LOCAL“ the remote control will be stopped and the device will be
switched into „HV-OFF“. In case of receipt of remote commands the device will be reactivateted
immediately.
Analogue control via analogue I/O can be selected by push button „LOCAL“ (exception see menu
„SET“, function 08), the yellow LED „REM“ is flashing. By pushing „LOCAL“ again the devices runs
back to the mode „HV-OFF“ and manual mode.
In menu “SET“ further configurations are possible. You can access the Menu by pushing button “SET“
into “OFF“ mode.
With push button “SET“ all function are available by scrolling. The desired function will be selected by
pushing “SET“ and “LOCAL“ simultaneously
⇒
Function “ENTER”.
The selected values will be stored and activated by the “ENTER“ function. If this has been made
successfully the unit is back in “HV-OFF“ mode.
Pushing the button “ESC“ is going back to menu “SET“ without any change of the pre-selected
values.
Pushing button “LOCAL“ is always leading back to manual mode. In this case the HV will be shut off.
(
⇒
HV-OFF).
If no push button of the menu will be switched the display is automatically going back to the mode
„HV-OFF“ after a delay time of 30 sec.