ISE | (800) 463-7731 www.ise-group.com
3 of 8
Attach Legs to Frame
Place one of the Legs (B) into the Frame End
(A).
Line up the holes on the Legs (B) with the
holes on the Frame (A) ends.
Insert four #M6 × 10 mm Allen Head Screws
(L) through the holes in the Frame End going
into the Leg and tighten securely with the
supplied Allen Wrench (J).
Repeat for the other Leg.
Attach Side Brackets
The Frame end with the Control Box
bracket should be placed on the side of the
desk where you plan to mount the Switch
(G) and Control Box (F). The example shows
a Switch on the left.
Note: Left will be right and vice versa
when viewing the frame upside down.
Slide the Side Brackets (C & D) into the
Frame ends until flush. Insert two M6 × 14
mm Allen Head Screws (K) through the
holes in the Brackets and into the Frame.
Using the supplied Allen Wrench, rotate
each screw just a few turns. After both
M6 × 14 mm Allen Head Screws are
inserted, tighten both screws securely.
Repeat for the other side of the Frame
assembly.
2
1
B
A
L
L
J
B
To avoid stripping the threads, always
insert and make the first few turns
of the screw BY HAND with an Allen
wrench (H), ensuring it is in straight.
L
#M6 × 10mm Allen
Head Screw
K
M6 × 14 mm Allen
Head Screw
Hardware at actual size
Hardware at actual size
Control Box Bracket on left
when flipped right side up
Rotate for Switch on right
prior to adding Brackets
Switch on left
C
D
K
K
Note: Legs are shown without
cables for clarity.
