ISANTA Senco Pro FinishPro10, Operating Instructions Manual

Page: 8 / 134

Finish Nailer Framing Nailer
8
MAINTENANCE
1
SYMPTOM
Air leak near top of tool. / Sluggish operation
SOLUTION
Verify air supply / tighten screws or install Repair
Kit – See Parts Manual
2
SYMPTOM
Air leak near bottom of tool / Poor return.
SOLUTION
Clean tool / tighten screws or install Repair Kit
See Parts Manual
3
SYMPTOM
Other problems.
SOLUTION
Contact SENCO.
TROUBLE SHOOTING
Should Staple Jam Occur:
Disconnect Air Supply
Remove Fasteners
Clear the Jam
Follow loading Procedure
TOOL ELEMENTS
FN1 Workpiece Contact
FN2 Exhaust
FN3 Trigger
FN4 Magazine
FN5 Inlet
FN6
Exhausr Rear
FN7 Workpiece Contact
FN8 Exhaust
FN9 Trigger
FN10 Magazine
FN11 Inlet
FN12
Exhausr Rear
FN13 Feeder Shoe
FN1
FN2
FN3
FN4
FN5
FN6
FN11
FN8
FN7
FN10
FN13
FN9
FN12
EN
Warning
y
Repairs other than those described here should be
performed only by trained, qualified personnel. Contact
SENCO for information at:
+31 320 295 575.
y
Read section titled “Safety Warnings” before maintaining
tool.
y
Only use spare parts specified by manufacturer or autho-
rized representative.
_______________________________________________
y
All screws should be kept tight. Loose screws result in
unsafe operation and parts breakage.
y
Check monthly
_______________________________________________
y
With tool disconnected, make daily inspection to assure
free movement of workpiece contact and trigger. Do not
use tool if workpiece contact or trigger sticks or binds.
_______________________________________________
y
Squirt Senco pneumatic oil (5 to 10 drops) into the air
inlet twice daily (depending on frequency of tool use).
Other oils may damage O-rings and other tool parts.
y
Some Senco tools are Oil Free and DO NOT require oil,
Check label.
_______________________________________________
y
Wipe tool clean daily and inspect for wear. Use non-
flammable cleaning solutions only if necessary.
y
Do Not Soak.
y
Caution: Such solutions may damage O–rings and other
tool parts.
y
Dispose of cleaning materials properly.