5
Connecting to early models of MC-E “Blue” controllers:
1. Open the front panel of the controller.
2. The 5-pin connector is sandwiched between the front panel and
the circuit board in the lower right-hand corner. Attach the cable
adapter to the controller
with the black wire up
. (Later models
have an RJ connector in the same location.)
3. Connect the Mini-receiver’s RJ-11 cable to the other end of the
cable adapter.
Connecting to KwikDial controller:
1. Remove the access panel of the controller.
2. The 5-pin connector is below the front panel, on the circuit board on the
right side. Attach the cable adapter to the controller
with the black wire down
.
3. Connect the Mini-receiver’s RJ-11 cable to the other end of the cable
adapter.