10
To Run an All Stations Cycle (ASC):
Running an All Stations Cycle is useful for troubleshooting a sprinkler system.
1. Start a Program (section above).
2. Use the UP
arrow key to move above “PGM C” to “TEST ALL” mode. Press the RIGHT
arrow key to start the
run time blinking.
3. Use the UP
or DOWN
arrow buttons to set the running time. All stations will run the same length of time, in
sequence, from lowest to highest possible.
4. Press ENTER
to start. (Leave the transmitter on during the ASC sequence.)
To Manually Turn On a Station or Zone:
1. Turn on the remote and press the UP
or DOWN
arrow button to scroll to the station number desired.
2. Press the RIGHT arrow button once to move to run time.
3. Use the UP
and/or DOWN
arrow buttons to set the station’s one-time manual running time.
4. Press ENTER
to start the station. The flashing rain-drop indicates a running station.
Note
: The controller may display a differing countdown. It has been overridden by the remote’s countdown.
To Stop All Watering:
Press the CANCEL
button.
To Change from One Running Station to Another:
1. Press the UP
or DOWN
arrow buttons to select the desired station.
2. Press RIGHT
arrow key to move to run time.
3. Set running time with the UP
or DOWN
arrow buttons.
4. Press ENTER
to turn on the new station. The previously running station will shut off .
