IRRA
flow
Laser Leveler User Manual
11
7000494 Rev C, USA
•
Using the provided allen wrench, tighten the shoulder screw
into the side of the IRRA
flow
Control Unit. The device should
swing freely with no looseness along the shoulder screw. You
should not be able to see screw thread.
•
Replace the black cap over the head of the shoulder screw.
Instructions for Use
•
The recommended workflow begins with verifying the patient is
in a resting position and the laser leveler is attached to the
control unit. The treatment normally occurs at the bedside but
anywhere with direct line of sight to the patient
’s head
may
work.
•
Rotate the body of the device towards desired target location
(away from eyes).
•
Push button to activate laser. A red mark shall appear on or
near the patient.
Note: Do not hold down the button.
•
Adjust the body of the device as need.
•
With the device hanging freely, adjust height of the IRRA
flow
Control Unit as necessary. Note: Do not hold onto the device
during height positioning.
•
Laser automatically turns off after approximately 20 seconds.
Disposal
Do not throw in trash. Recycle per your
facility’s
electronic waste procedure
and local regulations.
