Irradio XRD-1396U, User Manual

Page: 32 / 41

9
OPERATION
SWITCHING ON/OFF THE UNIT
Switch on the unit by pressing any button
(except
release button ( ) (2). When
system is on, press button (1) to turn
off the unit.
FACEPLATE RELEASE
Press release button (2) to detach the
removable faceplate.
SOUND ADJUSTMENT
Press SEL button (26) shortly to select the
desired adjustment mode. The adjustment
mode will change in the following order:
→ BAS → TRE → BAL → FAD → TA VOL → VOL
BAS: bass
TRE: treble
BAL: balance
FAD: fader
TA VOL: TA volume
VOL: volume
By rotating the audio knob (26) clockwise or
counter-clockwise, it is possible to adjust the
desired sound quality.
LOUDNESS
Long press the BAND button to active the
LOUD function. Press it and hold again to
cancel this function.
EQUALIZATION
Press EQ button (7) shortly to turn on
equalization function and to select desired
audio mode. There are five kinds of mode
as below:
→
FLAT
→
CLAS
→
POP M
→
ROCK
→
DSP OFF
DISPLAY INFORMATION
Press DSP button (13) to operate as the
conversion of each display mode as
follows:
- In case of receiving a RDS station
In radio mode:
->CT ->FREQ ->PTY -> PS
In CD (MP3/WMA) mode:
->CD (MP3/WMA) ->CT ->FREQ ->PTY
->PS
In case of PTY information, the display
shows as “NO PTY”.
1. In case of receiving a non RDS station
In radio mode:
-> CT ->FREQ -> ‘NO PTY’ ->
In CD mode:
-> CD -> CT -> FREQ -> ‘NO PTY’ ->
Each displaying time is several seconds,
and come back to 1’st position after several
seconds.
Notes:
1. CT = clock time
2. FREQ = frequency
LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated
functions on the display .
ESP FUNCTION
The unit can be shockproof between ten
seconds and twenty seconds.
RESET FUNCTION
RESET
button (24) must be activated with
either a ballpoint pen or thin metal object.
The
RESET button is to be activated for the
following reasons:
3. Initial installation of the unit when all
wiring is completed.
4. All the function buttons do not operate.
5. Error symbol on the display.
Note: if press
RESET button (24), the unit
can’t work yet, please use a cotton swab
soaked in isopropyl alcohol to clean the
socket on the front panel.
RADIO OPERATION
 SWITCHING TO RADIO MODE
Press MODE button (15) to select radio
mode, the radio mode appears in the
display together with the memory band
and frequency.
 SELECTING THE FREQUENCY BAND
At radio mode, press BAND button (22)