Page 22
To secure the lower sash in place, attach right
angle sash lock with 1/2
” Type A screws as shown.
Cut window Sash Foam to insert it in the gap
between the upper and lower sashes.
Finally inspect the installation and check for any
gaps or openings to the outdoor air.
Cover these gaps with the provided foam to make
sure no outdoor air leaks inside.
Wall Mounted Installation
Note: Remove ethe air conditioner and
hardware’s from
the carton and place on a flat surface.
Save carton and the installation instructions for future
reference.
Suggested tools:
1. Screwdriver (Medium size Phillips)
2. Tap measure or ruler
3. Knife or scissors
4. Level gauge
Hardware (packed with the unit)
Location Requirements:
1. To avoid vibration and noise, make sure the unit is
installed securely and firmly.
2. Install the unit where the sunlight does not shine
directly on the unit. If the unit receives direct sunlight,
build and awning to shade the cabinet.
2. There should be no obstacle, such as a fence or wall,
within 20
” from the back of the cabinet because it will
prevent heat radiation of the condenser. Restriction of
outside air will greatly reduce the cooling and heating
efficiency of the air conditioner.
4. Install the unit a little obliquely outward not to leak the
condensed water into the room.
5. Install the unit with its bottom portion 29.5
”- 60” above
the floor level.
6. The power cord must be connected to an independent
circuit. The yellow/green wire must be grounded.
Caution:
All side louvers of the cabinet must remain exposed to
the outside of the structure.
Note: After installation, make sure the air conditioner is
tilted 3-4
°
to the outside to allow water drainage and
perfect cooling efficiency.
Summary of Contents for U-SHAPE Series
Page 6: ...Page 6 ...
Page 27: ...Page 27 Function Buttons ...
