IROX CUBO-T, Manual

Page: 27 / 32

1. LCD (display) and keys
FULL SEGMENT DISPLAY
- After inserting the batteries, the full segment display is shown for a few seconds and a short beep sound is heard.
MODE key
- to change the time display (with running seconds or day of the week).
- Press and hold 3 secs to enter setting mode.
ALARM key
- to select the ALARM1, ALARM 2 or DATE display.
- Press and hold 3 secs to enter the alarm setting mode.
▲ / ▼ keys
- In setting modes, these keys are used to adjust the value. To quickly change a value in the setting, press and hold ▲ or ▼.
- In ALARM 1 or ALARM 2 dispaly: Activate/deactivate the corresponding alarm.
- In DATE display and if RC reception is ON: Press and hold ▲ 3 secs to start manually a new RC time reception. A short press of ▲ will stop it again.
LIGHT/SNOOZE key
- Backlight: Press key to activate the backlight for 8secs on. If any key is pressed within these 8 secs, then the backlight stays on.
- When ALARM active: Press to activate the 8 minute SNOOZE cycle.
BATTERY COMPARTMENT
Is designed for 2 batteries, size AAA. Please observe polarity when inserting batteries.
Important Note:
While a RC reception is active ( tower blinking), you may not enter any setting with the MODE or ALARM key. If you wish to do so, stop the RC reception by
pressing short ▲ or wait until the reception stops automatically.
- 27 -
(ENG)