The Divider (F) will attach to the unit in the same location
as the removed Right Side (B). Position the bolts and
dowels of the Divider onto the Back (D). Turn the arrows of
the Minifix Cams (H1) of Back clockwise to secure.
Tighten the Rafix Cams (H2) on the Top (C) and Shelf (E)
by turning ¼-turn clockwise. Do not exceed ¼ turn when
tightening Rafix Cams!
Note:
Make sure the Divider is positioned exactly as
shown.
#8
H6
H7
H8
Install four Minifix Bolts (H6), two Dowels (H7), and
four Rafix Bolts (H8) into each side of the Divider
Panel (F). Install each piece directly opposite itself
as shown.
#7
H8
#6
The height of the Top (C) is optional. Select the
height that suits your needs. If it wasn’t done
during assembly of the Base Carrel (LC36), screw
three Rafix Bolts (H8) into the appropriate set of
predrilled holes in the Side Panel (B) where
indicated. These should match the bolts already
installed on the Left Side Panel (A) of the Base
Carrel (LC36)
