Ironton 46682, Owner'S Manual

Page: 6 / 18

Page of 18 6
•
Check guard for proper closing before each use. Do not operate the saw if guard does
not move freely and enclose the blade instantly. Never clamp or tie the guard with the
blade exposed.
If saw is accidentally dropped, guard may be bent. Check to make sure that
guard moves freely and does not touch the blade or any other part, in all angles and depths of
cut.
•
Check the operation and condition of the guard return spring. If the guard and the spring
are not operating properly, they must be serviced before use.
Guard may operate
sluggishly due to damaged parts, gummy deposits, or a build-up of debris.
•
Assure that the guide plate of the saw will not shift while performing the ″ plunge cut ″
when the blade bevel setting is not at 90°. Blade shifting sideways will cause binding and
likely kick back.
•
Always observe that the guard is covering the blade before placing saw down on bench
or floor.
An unprotected, coasting blade will cause the saw to walk backwards, cutting
whatever is in its path. Be aware of the time it takes for the blade to stop after Trigger is
released.
•
DO NOT USE THIS SAW WITH THE SAW HELD UPSIDE DOWN IN A VISE. The saw is not
designed for such use and cannot be used safely in that position.
•
Do not use to cut logs, tree limbs, or uneven lumber.
•
Wet lumber, green (unseasoned) lumber, and pressure treated lumber all have an
increased potential for kickback and should only be cut with a blade for cutting that
lumber type. Wear a NIOSH-approved respirator and have appropriate ventilation
whenever cutting pressure treated lumber.
•
Do not use blades made from high-speed steel, abrasive blades, metal-cutting blades or
masonry-cutting blades.
The guards of this saw are not designed to protect against the failure
of such blades.
•
Place the larger portion of the saw base on the larger, supported part of the workpiece.
This will help maintain balance and control while the cut is completed.
•
Blades must be rated to at least the maximum speed marked on the tool.
•
Maintain labels and nameplates on the tool. These carry important safety information. If
unreadable or missing, contact the distributor for a replacement.
•
Avoid unintentional starting. Prepare to begin work before turning on the tool.
•
Do not lay the tool down until it has come to a complete stop. Moving parts can grab the surface
and pull the tool out of your control.
•
When using a handheld power tool, maintain a firm grip on the tool with both hands to resist
starting torque.
•
Do not depress the spindle lock when starting or during operation.
•
Do not leave the tool unattended when it is plugged into an electrical outlet. Turn off the tool,
and unplug it from its electrical outlet before leaving.
•
This product is not a toy. Keep it out of reach of children.