Ironton 46682, Owner'S Manual

Page: 11 / 18

Page of 18 11
4. Remove the Blade.
5. Install the new blade over the Arbor Adaptor Plate. Make sure the Arbor Adapter Plate is
properly seated on the Shaft. Guide the Saw Blade onto the pins of the Arbor Adaptor Plate.
The Saw Blade teeth at the bottom of the Saw Blade should be pointing toward the front of the
Saw.
6. Hold the Spindle Lock Button while using the Hex Wrench to replace the Blade Bolt, turning it
clockwise.
Adjusting Depth
7. Set the Base flat against the edge of the workpiece.
8. Twist Depth Adjustment around guard Base to adjust depth of cut.
WARNING:
To reduce the risk of serious injury, adjust the depth of cut to just barely clear
the workpiece and remove shavings.
Workpiece and Work Area Setup
1. Workpiece selection:
a. Workpiece must be free of foreign objects and loose knots.
b. Do not use to cut logs, tree limbs, or uneven lumber.
c. Wet lumber, green (unseasoned) lumber, and pressure treated lumber all have an increased
potential for kickback and should only be cut with a blade designed for cutting that lumber.
Wear a NIOSH-approved respirator and have appropriate ventilation whenever cutting pressure
treated lumber.
2. Designate a work area that is clean and well lit. The work area must not allow access by
children or pets to prevent distraction and injury.