Page of 12
4
Remove adjusting keys or wrenches before turning the power tool on. A wrench or a key that
is left attached to a rotating part of the power tool may result in personal injury.
Do not overreach. Keep proper footing and balance at all times. Proper footing and balance
enables better control of the power tool in unexpected situations.
Use safety equipment. Always wear eye protection. Dust mask, nonskid safety shoes, hard
hat, or hearing protection must be used for appropriate conditions.
Specific Safety Rules
Maintain label and name plate on the tool. These carry important information. If unreadable
or missing, contact the distributor for a replacement.
Always wear ANSI approved safety impact eye goggles and heavy leather work gloves when
using the tool. Using personal safety devices reduces the risk for injury.
Maintain a safe working environment. Keep the work area well lit. Make sure there is
adequate surrounding work space. Always keep the work area free of obstructions, grease,
oil, trash, and other debris. Do not use a power tool in areas near flammable chemicals, dust,
and vapors. Do not use this product in damp or wet locations.
When starting a handheld power tool, always maintain a firm grip on the tool with both hands
to resist starting torque.
Always keep the extension cord away from moving parts on the tool.
Avoid unintentional starting. Make sure you are prepared to begin work before turning on the
tool.
Do not force the tool. This tool will do the work better and safer at the speed and capacity for
which it was designed.
Never lay the tool down until the motor has come to a complete stop. The tool may create
unforeseen risk while the motor cycles down.
Never leave the tool unattended when it is plugged into an electrical outlet. Turn off the tool,
and unplug it from its electrical outlet before leaving.
Always unplug the tool from its electrical outlet before performing and inspection,
maintenance, or cleaning procedures.
WARNING:
People with pacemakers should consult their physician(s) before using
this product. Operations of electrical equipment in close proximity to a heart pacemaker
could cause interference or failure of the pacemaker.
Extension Cords
Grounded tools require a three wire extension cord. Double insulated tools can use either a
two or three wire extension cord.
As the distance from the supply outlet increases, you must use a heavier gauge extension
cord. Using extension cords with inadequately sized wire causes a serious drop in voltage,
resulting in loss of power and possible tool damage. (See Figure A, below)
The smaller the gauge number of the wire, the greater the capacity of the cord. For example,
a 14 gauge cord can carry a higher current than a 16 gauge cord. (See Figure A)
When using more than one extension cord to make up the total length, make sure each cord
