7
A. Slide the Actuator(F) to the last set of welded
tubes on the Main Extension Arm(B), Using a
18mm x 32cm Hex Bolt(T), two 18mm Flat
Washers(U) and a 18mm Lock Nut(V) at the
top. And using a 16mm x 13cm Hex Bolt(I),
two 16mm Flat Washer(K) a 16mm a 16mm
Lock Nut(L) on bottom to tight the Actuator.
STEP 3
STEP 4
A. Attach the Plastic Rim Height Indicator(G) and the
2 Spring-assists Cartridge(E) to the second set of
welded tubes on the Main Extension Arm(B) by
using a 20m x 32cm Hex Bolt(ZA), two 20mm Flat
Washers(X) and a 20mm Lock Nut(Y). The Plastic
Rim Height Indicator(G) should hang freely along
side the Spring-Assist Cartridge(E).
B. Attach the bottom of Spring-assist CartridgeS(E) to
the welded Actuator Bracket by using a 16mm x 18cm
Hex Bolt(J), two 16mm Flat Washers(K) and a 16mm
Lock Nut(L).
C. Remove and discard the blue plastic spreader tube from the
Spring-Assist Cartridges(E).
STEP 5
A. Attach the 2 Upper Extension Arms(C) to Main Post(A)
with a 18mm x 28.5cm Hex Bolt(W), two 18mm
Flat Washers(U) and a 16mm Lock
Nut(V).
NOTE: It does not matter which end of the Upper
Extension Arms you attach to the Main Post(A).
CAUTION: Injury may occur if Upper Extension
Arms are allowed to fall off Main Extension Arm
during assembly.
W
U
U
V
C
I
K
K L
T
U
U V
F
E
Z
X
X
Y
J
K
K
L
G
