8
Apply Rim Height Sticker
Use a tape measure to crank rim up to exactly 10'
from playing surface. Make a line mark on the
Actuator (C) against bottom edge of Actuator
Sleeve (D).
Crank the rim all the way down to the extreme end.
Peel and apply Rim Height sticker (J) to outside of
Actuator (C) lining up the mark with the 10' mark on
the Rim Height Sticker.
See Detail B.
Apply Pole pad if available.
10ft
Rim Height
sticker
Detail B
Actuator sleeve (C)
Figure 13
STEP 11
STEP 12
11.
Attach Backboard (H) to Lower Extension arm (F).
Turn crank to lower support frame (F) until against
safety stop rod welded on the back of Top Pole (B).
With 3 capable adults, raise the Backboard and rim
assembly up and connect Lower Extension arm (F) to
the Backboard Bracket using one Stud M12x235
(#2), 2 washers M12 (#8), 2 Plastic washers M12
(#1), and 2 Lock nuts M12 (#9).
Tighten this bolt snugly. See Figure 13.
Note:
1. Slide the Stud thru from outside of Vertical tubes. After
the stud is installed, plug end caps into the holes on the
vertical frame, to keep bees from holes. 4pcs plugs can be
found in the hardware pack or manual pack.
2. The plastic washer goes between backboard bracket (H)
and Lower extension arm (F).
Attach Backboard (H) to Upper
Extension arm (G).
Connect Upper board arm (G) to the
Backboard vertical frame (H) using 2 Hex
bolts M12x55 (#6), 4 Flat washers M12
(#8), 2 Plastic washers M12 (#1), and two
Lock nuts M12 (#9).
Tighten the two bolts and nuts snugly.
See Figure 13.
Note:
The plastic washer goes between
backboard vertical frame (H) and Upper
extension arm (G).
12.
13.
F
G
G
6
8
1
8
9
8
9
8
9
9
8
2
1
1
8
1
H
A
B
Actuator
(C)
