IRIS Touch
Quick Installation & Maintenance Guide Version 1.1 Page 11 of 16
Ethernet ETH2
Using the ETH2 Ethernet conneciton to the SPC Ethernet socket to run the EDP
protocol then perform the following:
Go into the ‘Installers Menu’ and enter in the installer code that you had setup
beforehand and then select the ‘Settings’ Menu.
Scroll down till you see the option for ‘Ethernet 2’ and select this option. Untick
‘Shared with Eth1’ and then tick the option for ‘Remote access’. The IP address
should be set to 172.16.25.1.
Go back to the main settings menu and then scroll down till you see the option
for ‘Panel Interface’ and select this option:
Now select the option for ‘Ethernet 2’ and select ‘Siemens SPC’.
Note: You will need to ensure that the Monitoring station (ARC) have set up the correct account setup
using a Remote Service setup with the correct Panel Config for SPC. Please contact Chiron Technical
support for more information if needed.
Panel Configuration
Panel configuration for dial capture
If you are connecting the IRIS Touch dialler via the dial capture method which is connecting the Telecoms
module to the dial port of the IRIS Touch, you will need to configure the following options:
Telephone Number = The 12 digit format of the monitoring centre IP address (e.g. 192.168.0.34 would
become 192168000034).
To select routing of an alarm over PSTN, place an extra digit “9” in front of the Tel 2 receiver telephone
number. This tells the IRIS communicator that it should route the call over PSTN if available. If there is a
PABX that requires a “9” to dial out of the site then place two ‘9’s’ in front of the Tel 2 number.
Account Number: 4 – 6 digit account number allocated by the monitoring centre.
Note: If the ‘Alarm Override’ mode is selected, the IRIS Touch dialler replaces the phone number and the
account number used by the alarm dialler with the IP address of the monitoring centre and account
number entered during configuration, so there is no need to change any settings on the alarm panel.
If using the PSTN Expansion board do not use alarm overide.
