DragonflyVR™
SETUP AND USER MANUAL
Page 7 of 14
©2016 Iris Dynamics Ltd.
03-200-001_A0.docx
www.irisdynamics.com
Assemble as follows:
1.
Unpack and unwrap all components onto a level, clean work area.
2.
Place the shaft collar clamp on the yoke
handle.
3.
Collar shown in place. Rotate the collar so the
split in the collar aligns with the split in the
bottom of the handle shaft.
4.
Turn the shaft on the yoke body 90 degrees to
one side, and then turn the yoke body itself
onto its side. This should place the RJ12
connector in the correct orientation and
expose the screw on the bottom of the shaft.
5.
Check the orientation and plug the RJ12
connector into the jack inside the handle. The
locking tab on the RJ12 connector should align
with the slot in the handle collar.
6.
Slide the yoke handle onto the actuator shaft,
and align the split in the handle collar with the
screw on the bottom of the shaft as shown.
7.
Tighten the socket cap screw in the clamping
collar using the 3/16” Allan key.
8.
Tighten the socket cap screw until the handle will not pull off the shaft.
9.
Your Flight Yoke System is now assembled.