Media Type (Continued):
!!
!!
!!
!!
!!
!!
!!
!!
!!
!!
!!
!!
!!
!!
!!
Motion Configuration:
!
Up to 3 MD (Motion Detection) areas can be enabled. Each MD can be individually enabled/disabled,
covering range defined and trigger sensitivity set.
!
To enable and verify MD areas, follow the steps provided below:
!
1.
Check the box to enable the motion area
!
2.
Drag and drop to position the motion window
!
3.
Hold and drag any corner of the rectangle to resize the window.
!
4.
Adjust the detection “Sensitivity” and “Object Size” of the MD area by dragging the pin of the slider
bars.
!
NOTE:
The “
Sensitivity
” setting applies to the sensitivity level of the motion detection feature; the higher the value,
the more sensitive the activation trigger. “Object Size” indicates the trigger threshold. A lower “Object Size”
value means it is easier to exceed the value, and thus trigger the motion event.
!
5.
The status chart shows motion activities. When the motion vector exceeds a threshold (the Object
Size), the motion trigger is activated.
!
6.
To enable other motion areas, repeat the steps above.
!
7.
Click on the “Apply” button to save the settings.
(c)2015 Iris Innovations Limited. All Rights Reserved. v01.00 27/03/15. E&OE
