12
13
Method of usage
Method of usage
5.Calf installation
·
Install the rotating shaft in calf fixed axis first, noticed the hole should be aligned, so
that the R shape pin assembly (Figure 1)
·
After calf is connected with the fixed axis aligned, then insert (Figure 2)
·
Plug R pin, then moved to the other side of the calf, and plug R pin (Figure 3)
·
Finished (Figure 4)
Note
Figure 1
Figure 2
Figure 3
Figure 4
Figure 1
Figure 2
·
When the chair is working under the lay down mode and the calf rest is lifting,
you can't press on the calf rest, avoid to the chair fall forward to cause injury.
·
Please check the massage hand is it in the seat position when you sit down,
avoid to uncomfortable feeling on your gluteus when you sit in because of the
human body weight.
（1）
（2）
·
Using head cushions can reduce the kneading massage intensity on neck and
shoulder, according to your needs to decide whether the head cushions is
needed (recommend head cushions). Backrest cushion and backrest connected
by zipper (1), head cushions and backrest pad connected by thread gluing (2).
Zipper
Thread gluing
6. Head cushions and backrest pad's dismounting and use manual
Figure 7
Figure 8
Figure 9
·
After the rear part finish, make the front part of the armrest close to the metal tube,
and insert the hook on the armrest front part to the seat frame metal tube. (Figure 7)
·
Press the armrest downward until it in the right position, then push the front part of
the armrest upward, make the hook which on the armrest front part close to the
metal tube, swing the armrest gently, check the armrest is it installed well. (Figure 8)
·
Align the hole on the metal tube which on the front part of the armrest, tighten the
cross screw on the armrest frame with a cross screw driver, finish the installation,
and the same steps for the two armrests. (Figure 9)
Summary of Contents for A389-2
Page 10: ......
