www.iReliev.com
12
STEP BY STEP OPERATION GUIDE FOR TREATMENT (AFTER CHARGING YOUR REMOTE AND PODS)
STEP 1 - Preparing Your Skin Before Using
Following the steps below can help prepare the skin for optimal electrical dispersion and increased stimulation sensitivity. Such
care may also help extend electrode pad life and may reduce the risk of skin irritation.
1.
Determine the electrode pad placement sites for the electrode pad(s).
2
. Wash the area with mild soap and water (do not use alcohol). Rinse and dry thoroughly.
3.
Trim excess body hair from the area with scissors (do not shave).
4.
If desired, apply iReliev
®
Conductive Gel or Conductive Spray to help increase conductivity. This may also reduce the chance of
skin irritation and may extend the life of the electrode pads.
5.
When removing electrode pads, always remove by pulling in the direction of hair growth.
6.
It may be helpful to apply iReliev
®
After Use Electrotherapy Lotion on electrode pad placement area when system is not in use
to help increase moisture of skin.
STEP 2 - Attach Electrode Pad to Receiver Pod
1.
Place the electrode pad with the contact plugs up onto a flat surface. Place the
receiver pod with the contact jacks down onto the electrode pad so that plugs and
jacks are aligned. Then press down until they are completely snapped in.
2.
Do not remove the clear plastic shield from electrode pad until the unit is ready to
be placed on the body.
STEP 3 - Attach Pod and Electrode Pad to Your Body
1.
Place the pod and electrode pad on your body as per the illustration on page 17.
Summary of Contents for ET-5555
Page 1: ...Expandable Wireless Pods Instruction Manual Model ET 5555...
Page 34: ...www iReliev com 34...
Page 35: ...www iReliev com 35...
