Irbis ATV250S, Manual

Page: 24 / 99

22
1. Place the transmission in neutral position.
2. Open the fuel switch.
3. Sitting on the ATV (Utility), pull the choke lever (1).
NOTE: The throttle position slide button , the damper is fully open. Button slide damper position, the damper is completely closed.
Damper is adjustable, in the end when you need to open the damper depends on the number of starts. To go forward the damper needs
is open.
1. Set the engine stop switch to position.
2. Twist the ignition key to the ON position so start working. So start working up to 5 seconds, and immediately after starting the
vehicle release the start button. If the engine does not start, release the starter interval of 5 seconds, and then start again. Repeat this
step until the engine starts.
3. The engine is hard to start, pull the choke lever to allow the engine to warm-up properly.
4. Rev the throttle a little (Not too much) to help engine warm-up.
NOTE:
Allow engine to warm-up before using, this will prevent premature engine wear.
Warm engine start
Warm engine does not normally need to use the throttle or choke to start. Use the damper would if spark plug becomes wet.
1. Park the vehicle in horizontal position,
2. The vehicle stationary, the engine in neutral, open the fuel switch, turn on engine, switch to the position.
3. If the engine temperature is too low, not easy to start, then you can continue to use the throttle, but do not keep reving.
4. If the engine starts immediately, release the throttle lever.
If the engine still not turning over there could be something wrong, please try again, after replacing the spark plugs.
Utility driving
1. This carriage can be taken from the vehicle, it consists baseplate, front backrest, left & right door plate, tailgate. When you fix the
carriage on the vehicle, you should follow this instruction.