RT-230-05
Configurable parameters
Rebonding
(default: enabled)
•
Enabled
: The router will ask for bonding after reset.
•
Disabled
: The router will not ask for bonding after reset. It is recommended to disable after successful bonding to
avoid unintentional or illegal rebonding and useless requests sent via RF for initial 10 s.
LED Indication
(default: enabled)
•
Enabled
: Normal operation mode is indicated by the LED (see the figure above)
•
Disabled
: Normal operation mode is not indicated by the LED. Initialization and bonding are indicated in any case.
Longer TX preamble
(default: enabled)
•
Enabled
: Routed packets will have prolonged preambles. This complies with the
setRFmode(0x10)
function.
Refer to the IQRF OS Reference guide.
•
Disabled
: Routed packets will have standard (not prolonged) preambles.
Wait Packet End
(default: enabled)
•
Enabled
: The
RFRXpacket()
function waits for finishing packet receipt (if the receipt started before
toutRF
timeout). This complies with the
setRFmode(0x40)
function. Refer to the IQRF OS Reference guide.
•
Disabled
: The
RFRXpacket()
function is terminated afteer
touRF
timeout.
RX Algorithm
(default: 2 – with checkRF)
•
1 – without checkRF
: RF packets are received via
RFRXpacket()
with
toutRF
= 200. The RSSI Threshold
parameter is not active (receiving is not restricted at all). The toutRF parameter is fixed to 200.
•
2 – with checkRF:
The
RFRXpacket()
function with variable
toutRF
is invoked in dependency on result of the
checkRF(x)
. Filtering level is set by next parameter (RSSI Threshold).
RSSI Threshold
(default: 5)
•
0 to 64
: It allows to set the level for filtering poor RF packets in case of RX Algorithm = 2. This complies with the
checkRF(x)
function. Refer to the IQRF OS Reference guide.
toutRF
(default: 5)
•
1 to 255
: Allows to specify
toutRF
. This should be setup according to
DLEN
to be slightly longer than the packet
itself. It is valid for RX Algorithm = 2 only.
RF Band and Channel
(default: 868 MHz, ch 52)
•
868 MHz, ch: 0 to 61
•
916 MHz, ch: 0 - 188
Configuration procedure
Router configuration can be read as well as written immediately after the router reset only.
Caution:
To reset the router in an reliable way it is necessary to wait ~5 s after unplugging the router from mains
before replugging.
Reading the configuration
•
Arrange hardware according the figure above in RF range and run the Router Configurator.
•
Reset the router.
•
Router configuration is automatically read after the router reset. It is indicated by the LED flash.
Writing the configuration
•
Arrange hardware according the figure above in RF range and run the Router Configurator.
•
Set desired parameters and click the Write button.
•
Router Configurator displays the "Make router reset" prompt.
•
Reset the router.
•
Router configuration is automatically written to the router.
•
The "New setup has been sent to the router" message is issued by the Router Configurator for ~2 s.
•
New configuration is read and the LED flashes for checking.
© 2013 MICRORISC s.r.o.
www.iqrf.org
MNRT23005_130220
Page 5