GW-GSM-02
GW-GSM Tool
GW-GSM Tool is a PC program for setup, operation, testing and debugging of the GSM part of the gateway. It is free to
download from www.iqrf.or
g/321
.
First steps
•
Press the power button for at least 3 seconds to wake up the GW (if in sleep mode).
•
Connect the gateway to PC using a USB cable.
•
Install
USB driver – Custom Class
. You can download it from www.iqrf.org/89. This driver is the same also for other
IQRF USB devices. See the IQRF Quick start guide www.iqrf.org/235. If the IQRF IDE or another software using the
same USB driver (e.g. IQRF UDU) is installed, this step can be omitted.
•
Run the
GW-GSM Tool
.
Caution:
No other program communicating with any IQRF device via USB (e.g. IQRF IDE or IQRF UDU) is allowed to
run at the same time.
Basic setup
Settings
– The tab to configure basic
gateway functions.
•
APN
– Access Point Name obtained
from the GSM network operator.
•
PIN
- if the SIM card is protected,
insert the PIN code and press
Update button
•
Time
– Time in
HH.MM.SS
format.
•
Date
– Date in
DD.MM.YYYY
format.
•
Set Time
button
– sets a new time
to the RTCC. Other settings stay
unchanged. Once the button is
pressed, the time and date are
enabled for editing. Another press
of the button will launch the RTCC
with updatded values.
Use SMS Alarm
– If the box is checked
the
Send SMS
function is enabled.
Telephone number must be specified in
the box below.
Use IP filtering
– If the box is checked the access restriction function is enabled. Only IP addresses listed in
Safe IPs
list
can communicate with the gateway.
Safe IPs
– To add a new address to the list, enter the address in the box below the list and press the
Add
button. To
remove an address from the list, select it and press the
Rem
button.
Update
button
- Updates the configuration of the
GW-GSM-02.
© 2013 MICRORISC s.r.o.
www.iqrf.org
UG_GW-GSM-02_131016
Page 9
The Settings tab