IQEYE TECHNICAL TRAINING
Settings Page - I/O Tab
Use these settings to configure the behavior of the relay output of your camera. You
may test your relay output configuration by pressing the 'relay' button at the bottom
of this page.
Activate from live view If "enabled", will place an "activate" button on the live
image viewing page. This button, like the one on the input/output settings page,
will activate the relay output.
Button text
The text on the
"activate" button on the live
image viewing page.
Relay state
The normal, non-
activated state of the relay.
Activation time
The duration of the activation. "momentary" activates the relay
for a fraction of a second. "toggle" causes relay activation to change the relay's
state from open to closed or from closed to open.
Forced idletime:
The minimum time between trigger events, including those from
the external relay, motion, and from "Relay" button presses. Your camera will not
trigger another event until the specified amount of time elapses after the last post-
trigger image. Go to the Trigger Settings page to set up trigger events. This is the
same setting as the 'forced idletime' item on that page.
Activate on motion
If "enabled", motion trigger events (configured on the motion
settings page). will activate the relay output.
Note that motion triggers will not operate the relay if IQrecorder is archiving images.
Activate on external trigger
If "enabled", the external relay input will activate the
relay output.
Analog output mode
Select what is output on the analog video connector.
