Bandwidth limit:
This sets the
maximum network bandwidth limit in
kilobits per second. "Unlimited"
means that image streams are
delivered at full speed. You may
wish to change this so that an image
stream doesn't take up all the
bandwidth in your network.
Specifying a non-zero value will
restrict your camera to that amount
of bandwidth. For example, a value
of 64 will limit the frame rate of your
camera so that it outputs no more
than 64 kilobits of image data each
second. The value "0" is will be
accepted as an alternate method of
specifying "unlimited."
IQEYE TECHNICAL TRAINING
Settings Page - Network Tab
Ethernet mode:
Sets the camera's ethernet connection mode. "Auto" is the default
value and autonegotiates the correct setting with the switch. If your switch is not set
to autonegotiate you can set the camera to 10Mbit or 100Mbit, full-duplex or half-
duplex. This setting should match your switch. Use extreme caution when changing
this setting as the incorrect value means you will no longer be able to connect to the
camera. Changing this value requires a reboot.
Mailserver:
the name or IP address of a SMTP (Simple Mail Transfer Protocol) server
on your camera's network. The mail server must be an SMTP server and must accept
connections on port 25.
Timeserver protocol:
Set this select box to 'none', 'ntp', or 'daytime', depending on
the timeserver protocol used by your network. Setting this to 'none' will mean that your
camera does not obtain its time from the network.
