iQ1014S
Operator’s Manual
888-274-7744
www.iqpowertools.com
TRANSPORT, SETUP & OPERATION
Transport
The iQ1014S weighs approximately 200 pounds and is
built on wheels to make transport easy.
Always observe safe lifting practices when
lifting the iQ1014S.
The iQ1014S is designed to be pushed by the handle at
the back of the machine.
Setup
Before powering or starting, check for damage that
could prevent this equipment from proper operation or
performing its intended function. Check for binding and
alignment of moving parts. Check for damaged, broken,
or missing parts.
• Before connecting the iQ1014S to a power supply, be
sure the voltage, cycle and phase of the job site power
source meet the requirements listed in Technical Data.
• If using an extension cord, make sure the length
and wire gauge corresponds to the requirements
listed in Technical Data. An extension power cord that
is too small in wire gauge (diameter), or too long in
length, will cause the motor to overheat and could
cause premature failure.
• Do not cover the motor vents as this could lead to motor
overheating.
4.1
If the diamond blade shows signs of fatigue cracking,
replace the blade before starting work.
• Inspect Blade for damage (1). Verify that the Blade
is correct for the material being cut.
• Inspect other areas for damage, including Frame
Assembly (2), Handle (3), and Cord Assembly (4).
DO NOT FORCE the blade to cut! It will do the job
better and safer at the rate for which it was designed.
PORTABLE GENERATOR:
If using a portable generator to provide power, ensure
the generator meets the following requirements to
operate a tool requiring 30 amp at 220v.
PRE-START INSPECTION:
The pre-start inspection should be performed before
beginning any job.