IPSO PC30, Re)Programming Manual

Page: 41 / 74

42
Rapidly going through a program
It is possible to go through the program rapidly by pressing " " (that is if acceleration " ACCL " is selected
in the "preprogram").
The seconds on the display are counted down faster. This acceleration is interrupted each time you come to an
important step (drain, cooldown, etc.). Then press the acceleration button to continue rapidly.
By means of this button it is possible to skip parts or the rest of the program.
It is not possible to advance the program during tumbling.
Programmed stop
When a time stop is programmed, the program will stop in that segment. The water remains in the tub, there is
no more drum rotation and the display shows “ StoP “.
After pressing the “START” button once more, the program resumes.
Stop with predetermined stop time.
If a predetermined stop time was programmed, the display will alternately show “ StoP.tiME “ and the
remaining stop time counting down. After the stop time has elapsed, the program will resume automatically.
The stop time can also be interrupted by pressing the “START” button.
Alarm signal.
If the alarm signal was programmed, this will be executed at the beginning of the stop time.This can be
interrupted by pushing the " START ", or the " STOP "button.
å
Soaking (SoAH)
When a soak is programmed, the program will stop in that segment. The water level will be brought to “ 25 “,
the temperature will be kept constant and there will be one left-right drum rotation every 3 minutes.
After pressing the “START” button once more, the program resumes.
å
Soak with predetermined soak ti
me.
If a predetermined soak time was programmed, the display will alternately show " SoAh.tiME "and the
remaining soak time counting down. After the soak time has elapsed, the program will resume automatically.
The soak time can also be interrupted by pressing the “START” button.
Alarm signal.
If the alarm signal was programmed, this will be executed at the beginning of the soak time. This can be
interrupted by pushing the " START ", or the " STOP "button.
å
å
Control of a program in progress
By pressing the " T " button for longer than 3 seconds and then letting go of this button, all steps that are put
in per program segment will be shown one after the other during 1 second . By pressing " T " once more and
keeping it depressed , the last step displayed is shown during this time span. After letting go of the " T " button
the next steps will be displayed.
At the end of a program segment " EntEr " will appear for about 3 seconds. If you want to proceed to the display
of the following segment, you must keep the " E " button depressed during this period. If not, the normal program
process will be displayed.
Operating mode 6