IPSO PC30, Re)Programming Manual, Page: 34 / 74

Programming mode 4
FrEE==XX = The maximum of segments available for programming
You can program a maximum of 160 segments.
Press " E ".
End = End of this program segment
Press " NO " to proceed automatically to the next program segment (transition to " XX.id YY ").
YY stands for the next program segment number.
Press " E " to put an end to the program.
Tu XXX = Tumble
This will be executed with a frequency of 6 sec. wash action and 9 sec. stop time. In case of frequency controlled
machines, the speed will be equivalent to the lowest programmed speed in that program.
Select the tumble time using “ X,X,X “ (from 30 to 999 sec.) and press “ E “ to confirm.
If no tumbling is required, “0” can be selected. There will then be a waiting time of 1 minute at the end of the
program.
ALArm.XXX
Here, the alarm can be activated again.
Select the duration of the alarm signal using “ X,X,X “ (between 0 and250 seconds) .
This option is only displayed if “ ALArm “ was selected during the preprogramming
.
If " 999 " was selected, the signal will be activated until the door is opened.
Data.XXXX
The new " checksum" is displayed for a few seconds at the end of programming. Then it proceeds to " StArt
".