Page 12
REMOTE CONTROL PROGRAMMING
Before the generator can be started , an initial start-up
procedure must be performed so the generator and the
remote control recognize each other.
NOTE:
YOUR REMOTE CONTROL IS ALREADY PROGRAMMED
IN FACTORY FOR YOUR CONVENIENCE.AND IT IS
READY TO START THE GENERATOR
.
If the remote control is replaced then you will need to
go through following procedure with new remote
control.
Press and hold the STOP button of the remote
control fob, the engine push button red light will
start flashing and then it will stay on.
1. Turn the battery switch to “ON”(l) position.
2. Press and hold the remote set button for 3-5
seconds until the light of the engine push
button light illuminates red.
Remote Set Button
3.
Press and hold the START button of the remote
control fob, the engine push button red light will
start flashing and then it will goes out.
Turn off the battery switch to “OFF”(O) position to
complete the pairing.
4.
5.
STOP
START
Engine push button
