CM-IW100T
Instruction Manual
6
Discard the foam block and card insert.
8.
Insert the Control Mount mounting cradle
into the opening in the wall.
Note: The roto-Lock system can accom-
modate wall thickness of 3/8” to 3/4”
and can be extended to 1 1/4” with the
removal of the toggle caps.
9. Hand-tighten the four Roto-Lock screws on
the Control Mount’s utility box as shown
in Figure 5. The Roto-Lock clamps will
automatically rotate into position behind
the wall and begin clamping the mount.
• When you notice resistance on the four
screws, the Control Mount has been
clamped successfully.
Important: nEVEr over-tighten
the roto-Lock screws.
10. If there is a wall stud up against one side
of the utility box that prevents one Roto-
Lock clamp from operating, secure the
box by hand-driving a 1½” #6 drywall
screw (not provided) through the angled
hole on that side of the chassis and into
the wall stud.
Important: Do not over-tighten
the drywall screw.
11. Connect the Cat5 cable from the wall to
the RJ-45 jack on the connector board
and then mount the iPod touch to the
connector board as noted in figure 6.
12
.
Place the iPod touch assembly into the
mounting cradle by aligning the mount
connector board with the slot opening
in the mounting cradle. A slight tight fit
between the connector board and the slot
opening will hold the weight of the iPod
touch. The iPod touch will fit snugly in the
cradle.
Figure 6: Connector Board
Figure 5: Roto-Lock Screw Locations
