LOAD NEW ROLL OF FILM
Push the roll of film fully onto the film holder until it can go no further.
(See picture One)
Make sure the seal gap is next to the upper case.
(See Picture Two)
Cut the corner off the end of the film at the seal gap.
(See Picture Three)
Feed the film over the film guide pipe.
(See Picture Four)
Beware of the cutting blade that is located behind the film guide pipe.
Pull the film towards the drive bands until the film just starts to go between the
bands.
(See Picture Five)
Beware of the cutting blade that is located behind the film guide pipe.
Press the yellow button (two) and the machine will pull the film through. When the
button is released, the machine will stop.
