MANUAL
• Subject to alteration! Version: November 2021
ipf electronic gmbh
│
Rosmarter Allee 14
•
58762 Altena
• Germany
│
Tel +49 2351 9365-0 • [email protected] •
4
5 Assembly / Mounting
Check the LED luminaire before installation to ensure it is complete and shows no signs of damage. Do not
use the luminaire or accessories if they are damaged, as there is a risk of injury.
The LED luminaire comes fully assembled. The luminaire is attached via optional mounting hardware:
AE000011
AE000012
AE000013
AE000017
(Mounting bracket V2A)
(Mounting bracket V2A
(Luminaire holder, Aluminium) (Mounting angle bracketV2A)
incl. Magnet)
If attached using the mounting brackets, the LED luminaire is continuously adjustable by 111° in its rotation
axis.
Use the special self-tapping screws supplied with the luminaire to fasten the mounting brackets!
When mounting the luminaire, make sure that the luminaire is fastened securely
and stably. If the luminaire falls, its weight poses a risk of
injury!
6 Connection
There is an M12-connector A-coded on the luminaire. Suitable connection material, cables and accessories
can be found in our range of accessories. For example, a three-core M12 cable socket, article no. VK200025,
is suitable.
PIN assignment of the M12 connector is as follows:
Pin 3 = 0V DC. 24V DC can be applied to PIN 1 or PIN 4 for power supply. It is
not necessary to assign PIN 1 and PIN 4 at the same time.
Through-wiring (cascading):
In addition to the M12-connector, an M12 socket is also attached to the lu-
minaire. Using a suitable connection cable, e.g. VK060F25, you can electri-
cally link several lights of this type.
The maximum current consumption of all connected devices must not
exceed 4A!
PIN 1 = 24V DC
PIN 2 = not used
PIN 3 = GND
PIN 4 = 24V DC
PIN 5 = not used