iPECS eMG80
System DECT Installation Guide
Issue 1.3
18
3.4.2.1 Mounting Base Station
The weight of a Base Station is approximately 460g (1.2lb.), so it can be mounted on a masonry
or dry-wall surface, wooden wall, or partition wall.
Before mounting Base Station permanently, you should determine locations that provide the best
coverage (refer to General Procedure for CRS). To wall mount the Base Station, perform the
following Steps:
1. Drill two 3.5mm holes in a fixed wall; to properly position the holes, use the mounting
template (last sheet of this manual) and copy it if necessary. The distance between
mounting holes is 121mm as shown in the image.
2. Insert anchors into the drilled holes.
3. Insert screws in the anchors, leaving a 3mm gap between the wall and screw head.
4. Mount the Base Station eyelets on the screws.
Figure 3.4.2.1 Back side of GDC-600BE
Before mounting base station permanently, you should determine locations that provide the best
coverage. The wall mounting procedure of a base station is as follows:
1. Drill two 3.5mm holes in a fixed wall. To properly position the holes, you can use mounting
template that is the last sheet of this manual and copy it if necessary.
2. Insert anchors into the drilled holes. Then insert screws in the anchors, leaving a 3mm gap
between the wall and screw head.
3. Mount the base station eyelets on the screws.
