Entry of the user password only allows status checks, unless the admin has
data download privileges.
CHANGING PASSWORDS
Please note that only the admin can change passcodes. Out of the box both
admin and user passcodes are blank. Once you change the admin passcode to
a nonblank code you must also change the user passcode to a nonblank code.
To change either the admin or user passwords, launch the management utility.
1. Enter “4” to select Change passcodes from the menu of options.
2. The utility will first lead you through a series of questions to
determine how best to communicate with the unit (see “SELECTING
AN IP ADDRESS FOR ACCESSING THE UNIT” on page 27).
3. When prompted, enter “a” to change the admin passcode or “u” to
enter the user passcode.
4. When prompted, enter the admin passcode.
5. When prompted, enter the new passcode. Passwords are limited to a
length of 12 characters, and should conform to hex-decimal format
(i.e., you may use any number 0 - 9 and any letter A - F).
6. When prompted, re-enter the new passcode to confirm the change.
IMPORTANT!
Do not lose the admin password. To reset the admin password
requires physical access to the unit and it would be necessary to contact
IPCopper tech support for assistance. IPCopper tech support would not be able
to remotely reset the password, however, they can provide specific instructions
on how the reset the password. This process may require a firmware upgrade.
Please note that it may be necessary to send the unit to IPCopper tech
support to have the password reset.
STATUS PAGE
To check the status of your USC10G4 unit, launch the management utility
(IPCD10G4_[your unit’s serial number].exe) and select Check Status from the
menu of options. The utility will lead you through a series of questions to
determine how best to communicate with the unit (see “SELECTING AN IP
ADDRESS FOR ACCESSING THE UNIT” on page 27), then retrieve the status
IPCopper USC10G4 Product Manual
31