7
TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
The motor fails to start after
being powered on.
-
The power cable has
come off.
-
The battery needs
recharging.
-
The power switch has
been damaged.
-
Dismantle the base to
connect the cables
soundly.
-
Charging
-
Replace the switch.
Abnormal sound heard in the
motor.
- The fastening screws for the
pump are loose.
- Tighten the screws.
Leakage occurs to the bottom
of the base.
- The inlet and outlet tubes of
pump are broken or are loose
at the connection.
- Dismantle the base and
tighten the tube clamps.
Poor Spray Pattern
(Atomization)
-
The spraying hole was
clogged.
-
Spraying hole and o-
ring worn.
-
Seal is upside down.
-
Filter screen was
clogged.
-
Leakage occurred to
tubes at joints.
-
Battery short of power.
-
Air remained in the
pump.
-
Remove foreign
matter.
-
Replace o-rings.
-
Correct by reversing.
-
Clean with clear water.
-
Tighten screws.
-
Alarm maybe out of
order, replace it,
charge.
-
Remove the nozzle or
extension rod to
discharge the air.
PARAMETERS AND SPRAY-HEAD FLOW RATE
1. Type: RO Chem
6. Size:
1.58”x7.5”x21.85” / 40 x 190 x 555mm
2. Pump: Mini-Diaphragm
7. Capacity: 4 Gallons / 15 liters
3. Charger: Input AC100-240V
8. New Weight: 16 lbs / 7.4kg
50/60 hz, Output DC12v 12a
9. Battery: 12v10ah (fully enclosed,
4. Flow rate: ½ GPM / 2.2 LPM maintenance free) Max Pressure: 0.4-0.45
Mpa
5. Nozzle: 120 degree
