- 11 -
Setting up your device
Before Starting
*Before setting up the device make sure of the following:
1.)
All the package contents are all included if anything is missing please contact the dealer
where the device was purchased from.
2.)
Check the power input cable is working correctly.
3.)
Check all cables to make sure there are no problems with it.
Hardware Connection
Please refer following procedure :
1.) Connect the Ethernet cable (RJ45) to the 9858 to your local area network.
2.) Then connect the power cable into the power input port of the 9858.
3.) Connect the device that you would like to control to the output plug on the top of the 9858.
4.) Switching the power source to ON status , this switch is located at the rear of 9858.
5.) After power on for around 45 seconds , there is a short beep sound for 9858 which means
the system reboot successfully
6. ) Go to page #14 for software installation guide
– use IP EDIT to log in the webpage of
9858.
Note: To change the network setting for WiFi connection ( if your Router without WPS function ) ,
please go to page # 12 to setup the WiFi connection manually .
Software Installation
The
Media Link - IP Family CD
comes with the device , it has all the necessary software to run
and setup the device.
IP Power Software:
IP Edit ( Required)
IP Power Center *(
For multiple IP Power devices control purpose )
Installing Software
1.) Place the
Media Link-IP Family CD
into the CD/DVD Rom drive.
(The CD will auto run , but if it does not go to the CD/DVD Rom drive and select the
“
autorun.html
” file.)
