802.11n lndoor Wireless Access Point
14
Note
-----------------------------------------------------------------------------------------------------------------------------
1. Enabling scan does not populate the security key, so you must still manually enter it.
2. Make sure your (local) AP, PCs connected and the remote AP to connect are on the same subnet with
different IP addresses.
3. If ping requests sent from PCs connected to your local AP are properly replied by the targeted remote
AP, Universal Repeater is successfully operating; if not, check your settings again.
-----------------------------------------------------------------------------------------------------------------------------------------
3.4.5 Access Control
Specify a list of devices to allow or disallow a connection to your wireless network via the device's MAC
addresses. To deactivate this feature, select "Disable"; to activate it, select "Allow" or "Deny"
(2.4GHz/5GHz).
MAC Filter Mode:
Select Allow or Deny from the drop-down list.
1.
To permit a wireless device to connect to your wireless network, select
Allow
, enter its MAC address,
click
Add
and then
OK
. Then only this device listed as “Allowed” will be able to connect to your
wireless network; all other wireless devices will be forbidden.
2.
To disallow a wireless device to connect to your wireless network, select
Deny
, enter its MAC address,
Summary of Contents for W75AP
Page 1: ......
