35
Point to synchronize a wireless network. Specify a valid value between 20 and 999. The default setting is
100. It is advisable to leave the default value unchanged.
Fragment Threshold:
Specify a valid Fragment Threshold value between 256 and 2346. The default is
2346. Any wireless packet exceeding the preset value will be divided into several fragments before
transmission.
RTS Threshold:
Specify a valid value between 1 and 2347. The default is 2347. If a packet exceeds the
preset value, RTS/CTS scheme will be used to reduce collisions. Set it to a smaller value provided that
there are distant clients and interference. For SOHO users, it is suggested to keep the default value
unchanged.
DTIM Interval:
A DTIM (Delivery Traffic Indication Message) Interval is a countdown informing clients
of the next window for listening to broadcast and multicast messages. When such packets arrive in the
router's buffer, the router will send DTIM (delivery traffic indication message) and DTIM interval to alert
clients of the receiving packets. Specify a valid value between 1 and 255. The default is 1.
Receive Signal Strength:
Configure signal strength for connected clients. When the wireless client’s
signal strength is lower than the setting value, the wireless client will not be allowed to connect to the AP.
Interference Mitigation:
Mainly used for reducing wireless or some non-wireless interference to enhance
transmission rate of your device.
Interference mitigation: interference mitigation mode, range: 0-4. The default is 2.
(1) Mode 0: All interference mitigation is disabled.
(2) Mode 1: Non-wireless LAN Interference mitigation is enabled.
(3) Mode 2: Wireless LAN Interference mitigation is enabled.
(4) Mode 3: Auto Wireless LAN Interference mitigation is enabled and active.
(5) Mode 4: Auto Wireless LAN Interference mitigation is enabled and noise reduction is enabled.
TX Power:
Used for configuring wireless transmission power. You can change the value according to your
actual network environment.
Power Lockout:
Once this option is enabled, you can’t modify power manually.
Preamble:
Mainly used for preamble synchronization. It is advisable to keep the default value unchanged.