IOXUS, INC.
18
Stadium
Circle
Oneonta, NY 13820
Toll Free: +1 877-751-4222
Fax: 607-433-9014
http://www.ioxus.com
2/21/2019
DOC 1-0004 Rev A
© 2017 Ioxus, Inc. All rights reserved.
8
Standby Mode
If uSTART
®
is in
Run Mode
and a vehicle’s battery charging system
has been inactive for more than 1 hour,
uSTART
®
will automatically enter
Standby Mode
in order to reduce energy consumption
.
If at any time
uSTART
®
detects a significant, rapid change in the voltage level (as will occur during engine start), uSTART
®
will automatically return to
Run Mode
and support the engine cranking event. It is not safe to handle or work
on uSTART™ when it is in
Standby Mode.
Standby Mode
is indicated by all LED’s being
off
while connected to battery power
.
uSTART
®
operation can
be confirmed by noting the change to a
solid
green LED
upon engine start, indicating a return to
Run
Mode.
Jump Start Mode
Jump Start Mode
allows uSTART
®
to charge up its ultracapacitors from a weak vehicle battery and provide
power to jump start the vehicle.
Jump Start Mode
can be
accessed through the uSTART App. The
green LED
will
flash
and the
yellow
LED
will
flash
as uSTART
®
charges its ultracapacitors. After the charging period finishes, the
green LED
will
flash
and the
yellow LED
will light
solid
indicating that the vehicle is ready to be started. Start the vehicle
immediately for best results. See the uSTART App User Manual for additional details.
Fault Mode
uSTART® has experienced an abnormal condition or fault, indicated by a
solid red LED
. See the
Troubleshooting section for more information.
Bluetooth Connection
uSTART is connected via Bluetooth when the
blue LED
is lit solid. See the uSTART App User Manual for
more details (note that the blue LED may be difficult to see in bright locations, shading the status LED area
may help with seeing it).
Flow Charts
The below flow charts can be utilized to move through the different modes of uSTART
®
The flow charts are
separated by mode and navigate through each mode separately. For example, if
Run Mode
is desired, use the
Run Mode
flow chart.
