IOtech Personal488, User Manual

Page: 23 / 150

Windows 98
Personal488 for Windows 95/98/Me/NT/2000
04-06-01
Installation 3-13
Hardware Installation for Windows 98 Users
Plug-and-Play Devices
Personal488/PCI
Personal488/ATpnp
Personal488/Card
1. If you have not already done so, shutdown Windows 98 after the IEEE 488 software has been
successfully installed.
2. Remove power from the PC.
3. Physically install your interface. As a quick reference,
Personal488/PCI installs into a 32-bit PCI expansion slot,
Personal488/ATpnp installs into a 16-bit ISA expansion slot, and
Personal488/Card installs into a PC card slot.
4. Return power to the PC. Windows will detect your new hardware when the computer powers up.
This completes the installation procedure.
“Non plug-and-play” Devices
Personal488/AT (AT488)
Personal488 (GP488B)
Personal488/MM
1. If you have not already done so, shutdown Windows 98 after the IEEE 488 software has been
successfully installed.
2. Remove power from the PC.
3. Physically configure the device’s jumpers and switches to match the resource settings Windows
reported during the driver installation.
Non plug-and-play board users: physically configure your board’s jumpers and switches
to match the resource settings Windows reported. If these settings conflict with other
hardware change the jumpers, switches, and Windows Resource settings to available
resources.
Reference Note:
Refer to Chapter 4, Hardware Configuration Reference for further information concerning
jumpers and switches.
4. Return power to the PC.
This completes the installation procedure.