IOtech DaqBoard/3000USB Series, User Manual

Page: 45 / 128

DaqBoard/3000USB Series User’s Manual
927593
Connections & Pinouts 2-1
Connections and Pinouts 2
68-Pin SCSI Connector (P5) …… 2-2
J5 and J6,
40-Pin Headers for Analog Channels
…… 2-3
TB7
4-Channel Thermocouple Terminal Block
…… 2-3
J7 and J8,
40-Pin Headers for Digital Ports, Counters, Timers, DACS, Triggers,
Pacer Clocks and Other Signals …… 2-4
CA-248,
40-Position Header to DB-37 Male,
Ribbon Cable
…… 2-5
TB-100
Terminal Connector Option
…… 2-6
TB-101
Terminal Board Option
…… 2-7
DBK215
16-Connector BNC Connection Module Option
…… 2-11
Hardware Setups …… 2-12
WARNING !
Turn off power to all devices connected to the system before making connections.
Electrical shock or damage to equipment can result even under low-voltage
conditions.
CAUTION
The discharge of static electricity can damage some electronic components.
Semiconductor devices are especially susceptible to ESD damage. You should
always handle components carefully, and you should never touch connector pins or
circuit components unless you are following ESD guidelines in an appropriate ESD
controlled area. Such guidelines include the use of properly grounded mats and
wrist straps, ESD bags and cartons, and related procedures.
Pinouts for both the TB-100 and the DaqBoard/3000USB Series boards follow. In addition, use of the
DBK215 is briefly discussed. Details and specifications for that expansion option are presented in
Appendix A.
DaqBoard/3031USB and DaqBoard/3035USB make use of J5 and J6 (two of the four 40-pin headers) for
analog expansion. Pinouts for these and the remaining two headers (J7 and J8) are included in this chapter.
A pinout for a 4-channel terminal board (TB7) is also included. The last section of the chapter illustrates
three scenarios for hardware setup.
68-Pin SCSI 40-Pin Headers (4) 4 Channel TC
Connector (P5) (J6, J5, J8, J7) Terminal Block (TB7)
Locations of Signal Connectors