![IOtech DaqBoard/3000USB Series User Manual Download Page 12](http://html1.mh-extra.com/html/iotech/daqboard-3000usb-series/daqboard-3000usb-series_user-manual_2088006012.webp)
IG-6
968492
DaqBoard/3000USB Series Installation Guide
WARNING !
Turn off power to all devices connected to the system before making connections.
Electrical shock or damage to equipment can result even under low-voltage conditions.
Scenario 1: Using CA-248 Cables to obtain DB37 Connectors
In this setup a CA-248 cable is connected to each of the 40-pin headers (J5, J6, J7, and J8). The result is
four male DB37 connectors which, as can be seen from the pinouts, offer the same signal connectivity as
the SCSI connector. Note that the J6 header is dedicated entirely to analog expansion and therefore is not
applicable to /3001USB or /3005USB. As in all scenarios,
a CA-179-x USB cable is used to connect the
/3000USB Series board to a USB port on the host PC
. USB2.0 is recommended.
If you need to find the name of your device, for example, if you are writing a custom program for multiple
devices, navigate from the Windows Desktop to the Device Manager. The navigation path is:
Start
Ö
Settings
Ö
Control Panel
Ö
System
Ö
Hardware(Tab)
Ö
Device Manager
Ö
Daqx PnP Devices
You will see the device listed in the format of DaqBoard/3000USB (see first figure, below).
You can change the name of the device by doing a
right-click
on the device name to open its properties
dialog box, then clicking on the Properties tab (see second figure). You can then change the
“FriendlyName” of the device.
Locating DaqXPnP Devices
Properties Dialog Box
Summary of Contents for DaqBoard/3000USB Series
