Page 4
TYPICAL WIRING DIAGRAM
For other diagrams, consult our Customer Service.
ILB-CP-L OPEN BOARD WITH TBTS TEST ACCESSORY
ILBCP_TBTS_L.EPS
AC (NORMAL)
DRIVER
IOTA ILB-CP
OPEN BOARD
EMERGENCY DRIVER
LED
LOAD
WHITE
WHITE
WHT/BLK
WHT/BLK
COMMON
UNSWITCHED
24/7 POWER
BLK/ORG (120 TO 277V, 50/60HZ)
BLACK (120V)
ORANGE (277V)
SWITCHED OR
UNSWITCHED
HOT
TBTS
TEST ACCESSORY
RED (+)
BLUE (-)
RED/WHT (+)
BLUE/WHT (-)
LED INPUT(+)
LED INPUT (-)
LED OUTPUT (+)
LED OUTPUT (-)
UNIT
CONNECTOR
WHT/RED
RED OR RED/BLK (+)
BATTERY PACK
BLA
CK
RED
BLA
CK
RED
6
CONNECT BATTERY BEFORE SUPPLYING AC POWER.
ATTENTION: DO NOT MATE UNIT CONNECTOR UNTIL
INSTALLATION IS COMPLETE AND AC POWER IS SUPPLIED.
TEST ACCESSORY LEADS-OBSERVE PROPER
POLARITY WIRING.
SELECT PROPER VOLTAGE LEAD. CAP UNUSED LEAD.
NO POLARITY ON WHT/BLK LEADS. USE EITHER LEAD FOR
CONNECTION TO BUILDING COMMON (SWITCHED OR UNSWITCHED)
AND OTHER FOR CONNECTION TO AC DRIVER.
CONNECT UNSWITCHED POWER. IF A SINGLE BUILDING
COMMON IS PRESENT, CONNECT THE WHITE WIRE TO THE COMMON.
IF A SEPERATE UNSWITCHED CONDUCTOR FEED IS PRESENT,
CONNECT THE WHITE LEAD TO THE COMMON FROM THE
UNSWITCHED FEED.
MATE UNIT CONNECTOR AFTER INSTALLATION IS
COMPLETE AND AC POWER IS SUPPLIED
6
68A10-CPL
REV 1605
